Bissell POWERCLEAN ION PET 2482 Series User Manual page 12

Maintaining the Brush Roll
WARNING
To reduce the risk of fi re, electric shock or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
1
Make sure the vacuum is OFF. Press
the vacuum foot Release Button to
disconnect it from the vacuum.
3
Slide the tab down to un-lock and lift the
corner cover piece.
5
If the Brush Roll stops spinning due to
debris, the LED light will turn solid red.
NOTE: Make sure the Brush Roll Cover Tab is locked back into place to prevent breaking
or faulty Brush Roll.
12
www.BISSELL.ca
2
Turn the foot over and locate the
Brush Roll Cover Tab. Use a coin to
remove the Brush Roll, turning counter-
clockwise to unlock.
4
Grasp the Brush Roll and remove from
the foot window area. Clean off hair or
debris from brush. Place the cleaned
Brush Roll back into the foot of unit and
use coin to turn lock clockwise to lock
into place.
6
BRUSH ROLL RESET:
Turn unit OFF and remove debris from
Brush Roll and Brush Roll End Cap area,
following the steps above. Replace Brush
Roll and turn unit ON to reset the brush.