Download Print this page

AeroGarden 100306-BLK Quick Setup Manual page 5

Garden input: 12vdc, 2.5a, adapter input: 100~240vac, 50/60hz, adapter output: 12vdc, 2.5a

Advertisement

Watering
Plants grown in the AeroGarden are designed to thrive with most
municipal tap water. If your water is especially hard, improved
results can be seen with distilled water or reverse osmosis water,
but this is not needed in most cases.
It's okay to add water to the 'Fill To Here' line any time.
For best growth, keep your garden topped up!
Good To Know:
Your pump will be ON when your Grow Light is ON,
and it will be OFF, when your Grow Light is OFF.
An Important Note About Watering:
Your AeroGarden has a Low Water shut off feature. If your reservoir
runs empty, your pump will stop and your LED Grow Light will turn
OFF. This will alert you that your AeroGarden needs water, and will
help slow down your plants water intake needs for a short while.
After you fill your reservoir with water, your LED Grow Light will
turn back ON and continue its Light ON cycle.
To Start a New Garden
When your 'Add Plant Food' alert is
OFF, gently touch and hold your finger
over the 'Light On/Off' button for about
10 seconds. The 'Add Plant Food' alert
light will blink 3 times to confirm your
AeroGarden has been reset. All of your
timers will be reset to start at this point
and you will be ready to plant again.

Advertisement

loading

This manual is also suitable for:

Sprout100306-wht100306-red100306-blu100306-cgy