AeroGarden Sprout Titan Tal

Quick Setup Guide

Simple Steps to Get Your AeroGarden Up and Growing
Sprout
Welcome to the world of
AeroGarden Sprout Model numbers: 100303-BLK/WHT/BLU/RD2/TEL
AeroGarden Sprout LED Model numbers: 100304-BLK/WHT/RED/TEL
Keep this Guide!
2 Easy Steps
To Get Your AeroGarden Up and Growing
1
Install CFL Grow Light into Light Hood
(If you have LED Grow Light,
skip this step)
Push CFL Grow Light straight into
socket inside Light Hood
DO NOT
TWIST
LIGHT!
Light Hood
(bottom view)
2
Set Bowl
into Base
Check to be sure that Bowl
is securely seated on
Air Coupling in Base.
Air
Coupling
Re se
t Nu
tri en
Wh en Nu t Ti m
Pre trie nt Lig er
ss & Ho ld ht is
2 sec On ,
on ds
O n
/O
Pr es
s &
Tu rn Re le
Li gh as e
t O n/ to Te
O m po
ra ril
y
CONGRATULATIONS!
Your garden is ready to grow.
It really is that easy!
For more details on planting, growing and
harvesting your AeroGarden, please turn the page
How to Raise and Lower
the Light Hood
To raise and lower the Light Hood, wrap one hand around the bottom
of the Light Post just above the Grow Deck. Grasp the upper part of
the Light Post with your other hand and push up to raise the Light
Hood or push down to lower
the Light Hood. The Light Post
will move up or down a notch
at a time with a little pressure,
or you can move it up or down
several notches at a time with
Push up to raise
more pressure.
Light Hood,
push down to
When planting a new Seed
lower Light Hood.
Pod Kit, the Light Hood should
be set to the lowest possible
position. For instructions and
tips about when to raise (or
not to raise) the Light Hood,
refer to Gardening Tips (on flip
side) and/or to Seed Pod Kit
Instruction booklet included in
each seed kit.
Sprout
&
LED
indoor gardening!
Electrical Rating: 120V~60Hz, 0.45A
Date Code
Electrical Rating: 120V~60Hz, 0.14A
AeroGarden Sprout
CFL Hood & Base
(Compact Fluorescent Light)
➠
Sprout
Reset Nutrient Timer LIGHT On/O
When Nutrient Light is On, Press & Release to Temporarily
Press & Hold 2 seconds Turn Light On/O

IMPORTANT SAFETY INSTRUCTIONS

When using this AeroGarden electrical furnishing, basic precautions should always be followed, including the following:
Read all instructions before using this AeroGarden furnishing.
(No tools required)
1. To reduce the risk of electric shock, the AeroGarden has a specific plug.
Do not change the plug in any way.
DANGER
– to reduce risk of electric shock:
2. Always unplug the AeroGarden from electrical outlet before cleaning or
changing Grow Lights (light bulbs).
WARNING
– to reduce risk of burns, fire,
electric shock, or injury to persons:
3. Unplug AeroGarden from outlet before putting on or taking off parts.
4. Close supervision is necessary when an AeroGarden is used by or near
children, invalids, or disabled persons.
5. Use AeroGarden only for its intended use as described in the instructions. Do
not use attachments not recommended by manufacturer.
6. Never operate AeroGarden if it has a damaged cord or plug, if it is not
working properly, if it has been dropped and damaged, or if it has been
dropped in water. If any of these conditions occur/exist, contact www.
AeroGardenSupport.com or your country's local distributor for instructions.
7. Keep cord away from heated surfaces.
8. Never operate furnishing with air openings blocked. Keep air openings free
of lint, hair, and the like.
9. Never drop or insert any object into any electrical openings.
10. Do not use outdoors.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
Included in Package
Sp ro ut
por arily
On /O to Tem
ase
s & t On/ Rele O
Pres Ligh (not included with LED model)
Turn
er
t Ti m
tri en On ,
t Nu ht is on ds
Re se nt Lig
en Nu trie ld 2 sec
& Ho
Wh Pre ss
CFL Grow Light
Model #100340
Order replacement Grow Light, extra Seed Pod Kits and Accessories at www.aerogarden.com
}
CFL Grow Light
(If you have LED Grow Light,
CFL Grow Light is not needed)
Light Post
Grow Deck
Bowl
- Side View -
Note: Do not place beneath
under-cabinet lights.
11. Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
12. Do not touch moving parts or hot parts such as pumps, lights, reflective
surfaces, and the like.
13. To disconnect, remove plug from outlet.
14. Do not place or submerge base, cord, plug, or Light Hood in water or other
liquid to clean it.
15. Do not allow water to contact hot Grow Lights.
16. Use only approved and supplied parts and accessories. Use only AeroGarden
Grow Lights with this AeroGarden model. Use of any other kind of accessory
is not recommended. Replacement parts can be ordered from www.
AeroGarden.com
17. Do not use AeroGarden for other than intended purpose.
18. This product is intended for household and residential use only. This product
is not approved for commercial applications.
19. If supply cord is damaged, it must be replaced by manufacturer, its service
agent, or similarly qualified technician in order to avoid a hazard.
20. Electrical wiring must be in accordance with local regulations.
21. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of appliance by a person responsible for their safety.
22. Children should be supervised to ensure they do not play with the appliance.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
(Dependent on model)
Or
Bowl & Grow Deck Seed Pod Kit
Light Hood
Light Post
Water Port Cover
- Fill To Here
View
Window
- Add Water
Base
Reset Nutrient Timer

Place Your Garden...

•
On a sturdy, water-tolerant surface
•
Under a space that allows 16" (41cm) clearance
for the full height of raised Light Hood
•
Near a standard electrical outlet, per local
regulations
•
In a 65-76°F (16-26°C) environment (optimal)
•
Away from reach of children or pets
•
Away from direct sources of heat (e.g., stove,
furnace vents) or cold (e.g., window drafts, A/C vents)
•
AeroGardens do not need additional light or a
sunny window. In fact, too much direct sunlight
can overheat your plants.
SAVE THESE INSTRUCTIONS
AeroGarden
Sprout LED
Re set
Nu trie
Wh
en Nut nt Tim
Pres rien er
s & Hol t Ligh t is
d 2 sec On,
ond s
On /O
Pre ss
& Rel
Tur n eas e
Lig ht On /O to Tem
por aril
y
LED Hood & Base
(Light Emitting Diode)
Add Nutrient
Sprout
On/O
LIGHT
When Nutrient Light is On, Press & Release to Temporarily
2 seconds
Press & Hold Turn Light On/O
- Front View -