HORNIT dB140 - Bike Horn Instructions Manual
![]()
INSTRUCTIONS
![HORNIT - dB140 - INSTRUCTIONS INSTRUCTIONS]()
- attach the handlebar mount to the handlebars using the rubber strap, ensuring that it Is securely fastened
- attach the trigger on the handlebars in a position where it can be pressed while operating the brake at the same time (see diagrams above for suggested set ups)
- wind the excess connecting wire around the handlebars. For best results on a road bike run the connecting wire under the handlebar tape
- attach the Hornit dB140 by sliding it into the mount. Remove it by pinching the release catches and sliding the Hornit dB140 out
- insert the connecting plug fully and firmly into the socket
- to operate press the trigger
- to change the sound press the sound selection button at the rear of the unit
FITTING AND REPLACING BATTERIES
The Hornit dB140 uses 2 x AAA 1.5V batteries. Unscrew the screw and lift the battery cover. Replace the old batteries with two new AAA batteries, ensuring correct polarity. Replace the battery cover and tighten screw.
![HORNIT - dB140 - FITTING AND REPLACING BATTERIES FITTING AND REPLACING BATTERIES]()
![]()
- Do not recharge non-rechargeable batteries.
- Remove rechargeable batteries from product before recharging.
- Do not mix different types of batteries or new and used batteries
- Only batteries of the same or equivalent type are to be used.
- Batteries are to be inserted with the correct polarity.
- Remove exhausted batteries from the product.
- Do not short circuit the supply terminals.
- Remove batteries if the product is not used for some time.
- Used batteries and broken electrical and electronic products must be disposed of at an approved collection
USING THE HORNIT dB140
Please read in FULL before use.
Water can ingress via the battery cover and the socket where the connecting plug inserts. The Hornit dB140 has an Ingress Protection rating (IP) rating of IP44. This means it is will work normally in extreme wet weather conditions. Do not submerge. The Hornit dB140 is designed for emergency use to prevent accidents and to be heard by drivers of other vehicles. Please use it responsibly.
WARNINGS
![]()
This product is not a toy and is not suitable for children.
![]()
Keep out of reach of and do not use near children or animals.
![]()
Prolonged exposure or incorrect use may cause permanent hearing damage. Do not use in confined spaces or near people's ears.
![]()
Ensure the Hornit dB140 is mounted correctly and securely, facing away from the rider.
www.thehornit.com
![]()
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download HORNIT dB140 - Bike Horn Instructions Manual
Need help?
Do you have a question about the dB140 and is the answer not in the manual?
Questions and answers