Advertisement
12
www.raider.bg
9. Installing the cutting knife.
► Fig.1: 1. Cutting lever
► Fig..2:
1. On / Off button
2.Block locking / locking button
To start, just press the power button
the speed is increased by increasing the pressure on the circuit breaker. Release the stop switch.
For long-term operation, press the switch, press the locking button, and then release the breaker. To stop the tool from the locked
position, push the switch all the way, then release it.
This tool can be used with an orbital or straight line (up and down)
Orbital cutting - the pressure is on the knife
To change the cutting, turn the lever to the desired position and select the appropriate cut according to the table.
Table 1
Insert the knife by loosening the bolt of the holder counterclockwise with hexagon.
► Fig.3
1. Knife holder 2. Bolt 3. Hexagon key With the blade of the knife facing forward, place it in the cutting disc holder as far as
possible. Make sure the back edge of the blade matches the roller. Then tighten the bolt clockwise to ensure that the blade holds
firmly.
► Fig.4:
1. Bolt
2. Roller
3. Cutting blade blade To remove the blade, follow the assembly procedure back.
NOTE: Lubricate the roller with grease from time to time.
Advertisement
