Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec PGGS 10-20V
Summary of Contents for Trotec PGGS 10-20V
- Page 1 PGGS 10-20V OPERATING MANUAL CORDLESS GLUE GUN...
-
Page 2: Table Of Contents
Distractions can cause you to lose control. Information marked with this symbol helps you to carry out your tasks quickly and safely. Follow the manual Information marked with this symbol indicates that the operating manual must be observed. cordless glue gun PGGS 10-20V... -
Page 3: Safety
Use of the power tool for operations different the power tool on. A wrench or a key left attached to a from those intended could result in a hazardous situation. rotating part of the power tool may result in personal injury. cordless glue gun PGGS 10-20V... - Page 4 The workpieces to be bonded General Power Tool Safety Warnings – Service must be clean, dry and free of grease. We recommend using the power tool with original Trotec accessories. • Have your power tool serviced by a qualified repair person using only identical replacement parts.
- Page 5 3. Do not insert the battery if the device is defective. Do not expose the battery to temperatures above 45 °C! Do not let the battery come into contact with water or fire! Avoid direct sunlight and moisture. There is a risk of explosion! cordless glue gun PGGS 10-20V...
-
Page 6: Information About The Device
Heat protection cover of the nozzle Scope of delivery • 1 x Device PGGS 10-20V • 1 x Rechargeable battery • 1 x Quick charger • 3 x Glue stick, length: 150 mm, diameter: 11 mm (transparent) • 1 x Transport case • 1 x Manual cordless glue gun PGGS 10-20V... -
Page 7: Transport And Storage
When the device is not being used, observe the following storage conditions: • dry and protected from frost and heat • Ambient temperature below 45 °C • Protected from dust and direct sunlight inside the transport case cordless glue gun PGGS 10-20V... -
Page 8: Start-Up
Allow the battery (6) to cool down to room temperature. 5. Take the battery (6) out of the quick charger (4) by pressing and holding the release button (9) and pulling the battery (6) off the quick charger (4). cordless glue gun PGGS 10-20V... - Page 9 1. Push a glue stick (7) into the feed channel (1). holding the unlocking button (9, I.) and pulling the battery off the device (II.). 2. If required, charge the battery (6) as described in the section Charging the battery. cordless glue gun PGGS 10-20V...
-
Page 10: Operation
1. Switch the device back on using the on/off switch (3) and check the status LED or the battery level indication to see whether the device needs to be charged or heated up. cordless glue gun PGGS 10-20V... -
Page 11: Available Accessories
• Check the on-site fusing. Shutdown • Check the quick charger for damage. If the quick charger is damaged, stop using it. Contact the Trotec customer • Switch off the device. service. • Hold onto the mains plug while pulling the power cable of •... - Page 12 Glued tiles in humid environments come loose: • Moisture penetrates into the glue joints. Use special cement-based glue sticks. Glued shoe soles come undone: • Moisture causes the leather to swell. Use special glue sticks. cordless glue gun PGGS 10-20V...
-
Page 13: Maintenance
• Dry the device with a soft, lint-free cloth. • Keep the connecting terminals on the device and charger clean. cordless glue gun PGGS 10-20V... - Page 14 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...