Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec PGGS 10-230V
Summary of Contents for Trotec PGGS 10-230V
- Page 1 PGGS 10-230V OPERATING MANUAL GLUE GUN...
-
Page 2: Table Of Contents
• Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce risk of electric shock. glue gun PGGS 10-230V... -
Page 3: Safety
This enables better control of the power tool in unexpected situation. • Dress properly. Do not wear loose clothing or jewellery. Keep your hair and clothing away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. glue gun PGGS 10-230V... - Page 4 Warning of hot surface We recommend using the power tool with original Trotec The insertion tool might still be hot after the accessories. application. Burn hazard when touching the insertion tool.
- Page 5 2. In an emergency, disconnect the device from the mains feed-in: Hold onto the mains plug while pulling the power cable out of the mains socket. 3. Do not reconnect a defective device to the mains. glue gun PGGS 10-230V...
-
Page 6: Information About The Device
• 1 x Power cable • 1 x Universal nozzle • 1 x Fine nozzle • 1 x Wide slot nozzle • 6 x Glue stick, length: 150 mm, diameter: 11 mm • 1 x Transport case • 1 x Manual glue gun PGGS 10-230V... -
Page 7: Transport And Storage
• ambient temperature below 45 °C 1. Push a glue stick into the feed channel (1). • protected from dust and direct sunlight inside the transport case Connecting the power cable 1. Insert the mains plug into a properly secured mains socket. glue gun PGGS 10-230V... -
Page 8: Operation
• Roughen smooth surfaces before gluing. ð The glue gun is ready for operation. Switching the device on and off Wear your personal protective equipment when working with the device. The device allows for both corded and cordless working. glue gun PGGS 10-230V... - Page 9 Only touch the nozzle by the heat protection cover! Wear protective gloves! Info Hold the device vertically with the nozzle pointing up so that no glue can escape. You can only exchange the nozzle while the device is warm. glue gun PGGS 10-230V...
-
Page 10: Errors And Faults
The glue does not come out evenly: • The device may not have reached the melting point yet. Allow the device to heat up completely. • Pull the feed trigger slowly and evenly. glue gun PGGS 10-230V... -
Page 11: Maintenance
Maintenance tasks which require the housing to be opened must only be carried out by authorised Glued tiles in humid environments come loose: specialist companies or by Trotec. • Moisture penetrates into the glue joints. Use special cement-based glue sticks. -
Page 12: Disposal
PGGS 10-230V... - Page 13 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...