Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec PGGS 10-3,7V
Summary of Contents for Trotec PGGS 10-3,7V
- Page 1 PGGS 10-3,7V OPERATING MANUAL CORDLESS GLUE GUN...
-
Page 2: Table Of Contents
Info Information marked with this symbol helps you to carry out your tasks quickly and safely. Follow the manual Information marked with this symbol indicates that the operating manual must be observed. Operating manual – cordless glue gun PGGS 10-3,7V... -
Page 3: Safety
Use of the power tool for operations different from those intended could result in a hazardous situation. Operating manual – cordless glue gun PGGS 10-3,7V... - Page 4 • The charger is only suited for indoor use. must be clean, dry and free of grease. • Keep the charger clean. Contamination entails a risk of We recommend using the power tool with original Trotec electric shock. accessories. Operating manual – cordless glue gun PGGS 10-3,7V...
-
Page 5: Information About The Device
The status LED indicates when the operating temperature has been reached by a change of colour. The heating time is 60 seconds. The ergonomically shaped handle and the light weight ensure fatigue-free working. Operating manual – cordless glue gun PGGS 10-3,7V... - Page 6 Nominal voltage 3.7 V Capacity 1.5 Ah Charger Nominal voltage input 100 – 240 V / 50 – 60 Hz Nominal current input 0.2 A Nominal voltage output 5.5 V Charging current 0.6 A Protection class II / Cable length 1.5 m Operating manual – cordless glue gun PGGS 10-3,7V...
-
Page 7: Transport And Storage
When the device is not being used, observe the following storage conditions: • dry and protected from frost and heat • ambient temperature below 40 °C • protected from dust and direct sunlight. Operating manual – cordless glue gun PGGS 10-3,7V... - Page 8 Green The battery is fully charged. The battery is empty. Recharge the battery. Inserting a glue stick 1. Push a glue stick into the feed channel (9). ð Charging requires approx. 3 hours. Operating manual – cordless glue gun PGGS 10-3,7V...
-
Page 9: Operation
• After cooling, remove the glue residues ideally with a sharp knife. • The glue joints can be painted. • Roughen smooth surfaces before gluing. Switching the device on and off Wear your personal protective equipment when working with the device. Operating manual – cordless glue gun PGGS 10-3,7V... - Page 10 1. Allow the glue gun to heat up. Push a glue stick suitable for the material into the feed channel (9) from the rear. Pull the feed trigger (5) to control the flow of glue for the intended task. Operating manual – cordless glue gun PGGS 10-3,7V...
-
Page 11: Errors And Faults
• Check the charger connection for dirt. Remove any dirt. • The workpiece consists of metal and may have heated up. • The battery might be defective. Contact the Trotec Wear protective gloves when working with the glue gun. customer service. -
Page 12: Maintenance
• Dry the device with a soft, lint-free cloth. • Keep the connecting terminals on the device and charger clean. Operating manual – cordless glue gun PGGS 10-3,7V... - Page 14 Trotec GmbH & Co. KG Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...