Table of Contents
Advertisement
Hardware Setup
Tools and Parts for Component Installation
Please prepare the tools and parts below before setting up your Synology NAS:
• A Screwdriver
• At least one 3.5" or 2.5" SATA drive (please visit
models)
Warning:
If you install a drive that contains data, the system will format the drive and erase all existing data. Please
back up any important data before installation.
Install Drives
1 Push the upper case in the direction as shown below. Lift the upper case and set it aside.
2 Install drives:
• For 3.5" drives with 3 screw holes on each side (indicated below):
a Slide the drive into the hard drive bay, and push it all the way until it's firmly connected to the SATA
connector.
b Secure the drive with the screws provided.
• For 3.5" drives with 2 screw holes on each side (indicated below):
a Place the HDD bracket on your Synology NAS, and fasten the bracket to the Synology NAS with the
screws provided.
8
www.synology.com/compatibility
for compatible drive
2
Chapter
Advertisement
Table of Contents
