Link To Cell - Panasonic KX-TGF882 Quick Manual

Link to cell

You can connect your base unit and cellular phone using Bluetooth
make or answer cellular calls using your phone system. For more details, please visit our Web site:
http://shop.panasonic.com/bluetooth-phone
L Locate your cellular phone near the base unit. If the cellular phone is too close to the base unit during a
cellular call, you may hear noise. For best performance, we recommend placing the cellular phone
between 0.6 m to 3 m (2 feet to 10 feet) away from the base unit.
1 Cellular line
2 Cellular phone service providers
Pairing a Bluetooth cellular phone
1
Base unit:
Press and hold {CELL 1} or {CELL 2} for about 5 seconds.
L After the corresponding CELL indicator on the base unit starts flashing, the rest of the procedure must
be completed within 5 minutes.
2
Your cellular phone:
While the corresponding CELL indicator is flashing, follow the instructions of your cellular phone to enter
the pairing mode.
L Depending on your cellular phone, it may ask you to enter the Bluetooth PIN (default: "0000"). If your
cellular phone shows PassKey confirmation on its display, follow the directions to proceed.
3
Base unit:
Wait until a long beep sounds.
L It may take more than 10 seconds to complete pairing.
L When the corresponding CELL indicator lights up, the cellular phone is connected to the base unit. You
are ready to make cellular calls.
Note:
L Make sure that your cellular phone is set to connect to this product automatically. Refer to your cellular
phone's operating instructions.
Base unit: CELL indicators
Status
On
Flashing slowly
Flashing rapidly
Light off
Trademarks
®
L The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any
use of such marks by Panasonic Corporation is under license.
L All other trademarks identified herein are the property of their respective owners.
Meaning
A cellular phone is connected. Ready to make/receive cellular calls.
− The cellular line is in use.
− Phonebook entries are being copied from a cellular phone.
− The base unit is searching for the paired cellular phone.
− The base unit is pairing a cellular phone.
− A cellular call is on hold.
− The remote voice assist feature is in use.
A cellular call is being received.
− A cellular phone is not paired to the base unit.
− A cellular phone is not connected to the base unit.
– 4 –
®
wireless technology, so that you can
1
2