Toro TimeCutter 75746 Operator's Manual page 42

Figure 60
1. Wood block—6.6 cm
(2-5/8 inches) thick
6. Remove the hairpin cotter and washer from the
lower lift-arm pin (Figure
Figure 61
1. Height-of-cut plate
2. Hairpin cotter
7. Rotate the height-of-cut plate to a different hole
so that it supports the weight of the mower deck
after you install the plate
g308865
2. Wood block—7.3 cm
(2-7/8 inches) thick
61).
g294197
3. Washer
(Figure 62).
8. Install the washer and hairpin cotter
9. Repeat steps
the machine.
10. Check the side-to-side level again; repeat this
procedure until the measurements are correct.
11. Continue leveling the mower deck by checking
the front-to-rear blade slope; refer to
the Front-to-Rear Blade Slope (page
Adjusting the Front-to-Rear Blade
Slope
1. Rotate the adjustment nut in the front of the
mower (Figure
1. Adjusting rod
2. Adjusting block
2. To raise the front of the mower, tighten the
adjustment nut.
42
Figure 62
(Figure
6 through 8 for the other side of
63).
Figure 63
3. Adjustment nut
g294195
61).
Checking
41).
g294471