Bosch 0603676000 Instructions Manual page 29

OBJ_BUCH-2116-003.book Page 29 Monday, September 5, 2016 5:52 PM
Press the "MTR" button 8. As long as you hold down the "MTR" button 8,
the calculated horizontal mitre angle "MTR", which has to be set on the mi-
tre saw, will be displayed. At the same time, the "MTR" indicator will light
up in the display.
Note: The calculated mitre angle "MTR" can only be taken over for chop and
mitre saws, for which the setting for vertical cuts is 0°. When the setting for
vertical cuts is 90°, the angle for the saw must be calculated as follows:
90° – indicated "MTR" angle = angle to be set on the saw.
Measuring "Compound Mitres"
"Compound mitre" measurement ("Compound MTR") is used to calculate
horizontal and vertical mitre angles when two workpieces with multiple an-
gles (e.g. crown mouldings) have to join precisely.
First measure the spring angle (SPR) and the corner angle (CNR). The meas-
uring tool will then calculate the mitre angle (MTR) and the bevel angle (BVL).
SPR
Carry out the worksteps exactly in the given sequence.
Bosch Power Tools
MTR MTR
CNR
English | 29
1 609 92A 1XZ | (5.9.16)