Specifications - Makita AN911H Instruction Manual

ENGLISH (Original instructions)
4-1. Adjuster
5-1. Too deep
5-2. Flush
5-3. Too shallow
6-1. Hook
6-2. Screw
7-1. Protrusion
7-2. Hole
7-3. Nose adapter
8-1. Latch lever
8-2. Door
9-1. Adjustfit

SPECIFICATIONS

Min. hose diameter
Dimensions (L X W X H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Wear safety glasses.
･
Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2 "x 4" housing.
Noise
The typical A-weighted noise level determined according
to EN792:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
9-2. Change plate
9-3. Arrow
10-1. Door
10-2. Feed claw
10-3. Driver channel
11-1. Trigger
11-2. Contact element
12-1. Trigger
12-2. Workpiece
12-3. Contact element
13-1. Trigger
13-2. Change lever
Model
Air pressure
Nail length
Nail capacity
Net weight
) : 90 dB(A)
pA
) : 103 dB(A)
WA
Wire-collated coil nail 45 mm - 90 mm
Sheet-collated coil nail 45 mm - 65 mm
Wire-collated coil nail 150 pcs., 200 pcs., 250 pcs,300 pcs
END106-2
Vibration
The vibration emission value determined according to
EN792 :
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENE059-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
ENG102-3
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
14-1. Thickness of workpiece
14-2. 10 mm or more
14-3. C-chaped steel (Thickness 1.6 -
3.2 mm)
15-1. Nail length
15-2. Wood thickness
15-3. Concrete range 10-15 mm
19-1. Cap
20-1. Drain cock
21-1. Air filter
22-1. Oiler
22-2. Pneumatic oil
AN911H
1.28 - 2.26 MPa (12.8 - 22.6 bar)
Sheet-collated coil nail 200 pcs
5.0 mm
293 mm X 125 mm X 319 mm
2.4 kg
) : 4.5 m/s
h
2
ENG233-2
2
ENG901-1