Appx. 2.1 Payload (Continue) - Semtech TBMS100 Reference Manual

Appx. 2.1 Payload (continue)

Cmd Command
Bit [7:0]
Config Configuration (​ 0 ~4 bytes )
See the table as follows:
© 2019 Browan Communications Inc. All rights reserved.
1 byte
0x00 – Set reporting interval in sec.(per unit:5min)
default value : 3600 sec
value range : 15~65535
0x02 – Set occupied interval in sec.
default value : 600 sec
value range : 0~65535
0x03 – Set ​ f ree detection time in min.
default value : ​ 5 min
value range : 0~255
0x04 - Set trigger count in the occupied status​ .
default value : ​ 0
value range : 0~65535
0x05 - Set ​ P IR parameters.
default value : please see 4.2.1.
Cmd
0x00
(Only for unconfirmed downlink)
0x00
*Note: little-endian format.
(Must be lesser than "keep-alive time")
0x02
*Note: little-endian format.
(Must be lesser than "keep-alive time")
0x03
0x04 Trigger Count in the occupied status
*Note: little-endian format.
0x05
*Note: little-endian format.
Command Description
Get Sensor Configuration
reporting interval in sec
Occupied interval in sec
Free detection time in min
PIR Parameters (see 4.2.1)
Config Length
0 bytes
2 bytes
2 bytes
1 byte
2 bytes
4 bytes
16