Table of Contents
Advertisement
MAINTAINING YOUR MODEL
Suspension and slipper clutch assembly removal
Your Slash 4X4 was designed with ease of disassembly in mind. The entire front and rear suspension assemblies can be removed from the
chassis fully intact with the removal of only a few screws. Refer to the exploded views included in the your model's Service Support Guide
for complete assembly diagrams.
Removing the front suspension module
1. Remove the two 4x12 button-head cap screws from the front of the chassis.
2. Remove the two 4x10 button-head cap screws from the top of the chassis.
3. Remove the 3x15 button-head cap screw from the steering link under the chassis.
4. Pull the front suspension assembly away from the chassis.
5. The driveshaft will come out with the front module. Remove screw pin to remove driveshaft.
Removing the rear suspension module (Slipper clutch assembly removal)
1. Remove the two 4x12 button-head cap screws from the top of the chassis.
2. Remove the two 4x12 button-head cap screws from the
bottom of the chassis.
4x12 BCS
3. Pull the rear suspension assembly away from the chassis.
4x10 BCS
4. The slipper clutch assembly can now be removed.
Slipper Clutch
Assembly
4x12 BCS
Rear Suspension
4x12 BCS
Assembly
3x15 BCS
Front Suspension
Assembly
SLASH 4X4 • 29
Advertisement
Table of Contents
