Yamaha KODIAK 700 Owner's Manual page 41

EBU30466
On-Command drive switch "4WD/LOCK"
(YFM70KPXJ / YFM70KPAJ / YFM70KPHJ /
YFM70KPSJ)
Stop the ATV and push this switch to change from
standard four-wheel drive to four-wheel drive with
the differential locked. Select the appropriate
switch position according to the terrain and the
conditions.
 "4WD" (four-wheel drive): Power is supplied to
the front and rear wheels, with the front differen-
tial unlocked.
 "LOCK" (four-wheel drive with the differential
gear locked): Power is supplied to the front and
rear wheels and the differential gear is locked.
Unlike in four-wheel drive, all wheels turn at the
same speed, giving maximum traction.
EWB00132
WARNING
Always stop the ATV before changing from
four-wheel drive to four-wheel-drive differen-
tial gear lock or vice versa.
The ATV handles differently in four-wheel drive
than in differential gear lock in some circum-
stances. Changing from four-wheel drive to
differential gear lock or vice versa while mov-
ing may cause the ATV to handle differently un-
expectedly. This could distract the operator
and increase the risk of losing control and
causing an accident.
1. On-Command drive switch "4WD/LOCK"
2. Drive switch lock lever
To access the "4WD/LOCK" switch, set the
"2WD/4WD" switch to "4WD", and then move the
drive switch lock lever to the right.
TIP
 When the switch is set to "LOCK" or "4WD", the
differential gear lock icon and indicator light will
flash until the differential gear is completely
locked or unlocked.
4-12
1
LOCK
4WD
2
4