Yamaha KODIAK 700 Owner's Manual page 35

The multi-function display is equipped with the
following:
 speedometer
 odometer
 two tripmeters
 clock
 hour meter
 fuel gauge
 error code display
Speedometer
The speedometer shows the vehicle's traveling
speed. The speedometer can be set to "mph" or
"km/h". This also changes the odometer and trip-
meter units between miles and kilometers. To
change the display between "mph" and "km/h",
turn the key to " " (off), then while holding the
"SELECT" button pushed, turn the key to "
(on).
Odometer and tripmeters
The odometer shows the total distance traveled
by the vehicle. The odometer can be used for
maintenance and service intervals.
The tripmeters show the distance traveled since
they were last reset. The tripmeters can be used to
record the distance traveled on a single trip, or to
estimate the distance that can be traveled with a
full tank of gas, etc.
Push the "SELECT" button to switch between the
odometer "ODO" and the tripmeters "TRIP A" and
"TRIP B" in the following order:
ODO → TRIP A → TRIP B → ODO
To reset a tripmeter, set the display to the tripme-
ter you want to reset, then push the "RESET" but-
ton for three seconds.
TIP
 The odometer will lock at 99999.
 The tripmeters will reset and continue counting
after 9999.9 is reached.
"
Clock and hour meter
The clock displays time in 12-hour format.
The hour meter shows the total time the engine
has been running.
Push the "CLOCK" button to switch between the
clock "CLOCK" and the hour meter mode
"HOUR" in the following order:
CLOCK → HOUR → CLOCK
4-6
4