Cleaning And Storage - Toro Wheel Horse 523Dxi Operator's Manual

Maintenance

Cleaning and Storage

1. Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
"STOP" to stop the engine. Remove both the
ignition and "Key Choice" keys.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine. Clean debris from the (3) air intake
screens, the radiator screen, and the rear
transaxle cover; refer to Check for Debris,
page 16.
IMPORTANT: You can wash the machine
with mild detergent and water. DO NOT
PRESSURE WASH THE MACHINE.
Pressure washing may damage the electrical
system or wash away necessary grease at
friction points. Avoid excessive use of water,
especially near the control panel, lights,
engine, and the battery.
3. Perform all of the service operations that are
required for storage; refer to Service Interval
Chart, page 30.
4. Remove the battery from the chassis, check the
electrolyte level, and charge it fully; refer to
Battery, page 44. Do not connect the battery
cables to the battery posts during storage.
IMPORTANT: The battery must be fully
charged to prevent it from freezing and being
damaged at temperatures below 32 F (0 C). A
fully charged battery maintains its charge for
about 50 days at temperatures lower than
40 F (4 C). If the temperatures will be above
40 F (4 C), check the water level in the
battery and charge it every 30 days.
5. For long–term storage (more than 90 days) drain
the fuel tank; refer to Draining the Fuel Tank,
page 38. Dispose of fuel properly. Recycle in
accordance with local codes.
IMPORTANT: Do NOT run the engine until
it uses up all of the fuel and stops. The fuel
injector pump on the engine requires fuel for
lubrication.
50
6. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged or
defective.
7. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service
Dealer.
8. Store the machine in a clean, dry garage or
storage area. Remove both the ignition and "Key
Choice" keys and put them in a memorable place
out of the reach of children. Cover the machine
to protect it and keep it clean.