Weber SPIRIT E-210 CLASSIC Owner's Manual page 27

BURNER TUBE CLEANING
OR REPLACEMENT (continued)
Reinstall Burner Tubes
For Spirit grills with 2 burners (210 model):
™
A) Put burner tube 2 inside cookbox and pass the front
end of tube out through burner tube 2 opening. Note:
Single row of burner ports should be facing up. Slide
burner tube 2 under the guide screw and washer (1).
B) Put burner tube 1 inside cookbox and pass igniter
wires and the front end of tube out through burner
tube 1 opening (2).
C) While holding burner tube 1, insert left side of
Crossover tube into Crossover
™ ™
Guide right side of Crossover tube into Crossover
™
burner hole in burner tube 2 (not pictured). Note: The
Crossover tube burner ports should face the front of the
™
cookbox.
D) Slide burner tube 1 under the guide screw and
washer (4).
For Spirit grills with 3 burners (310 model):
™
A) Put burner tube 2 inside cookbox and pass the front
end of tube out through burner tube 2 opening (1).
Note: Single row of burner ports should be facing up.
B) Slide Crossover tube alignment guide over the
™
end of burner tube 2 (2). Note: The Crossover
burner ports should face the front of the cookbox. With
Crossover tube attached, slide burner tube 2 under
™
the guide screw and washer (3).
C) Put burner tube 3 inside cookbox and pass the front
end of tube out through burner tube 3 opening (not
pictured). Insert right side of Crossover
Crossover burner hole in burner tube 3. Slide burner
™
tube 3 under the guide screw and washer (4).
D) Put burner tube 1 inside cookbox and pass igniter
wires and the front end of tube out through burner
tube 1 opening (5).
E) While holding burner tube 1, insert left side of
Crossover tube into Crossover
™ ™
burner tube 1 under the guide screw and washer (6).
ANNUAL MAINTENANCE
1
burner hole (3).
™
tube
™
2
tube into
™
burner hole. Slide
3
4
1
2
3
4
5
6
WWW.WEBER.COM
27