Basic Functions; Plug And Play (For Tuner Installation) - Philips DC177 User Manual

IMPORTANT:
Before you operate the system, complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
1
When you turn on the main supply, "AUTO
INSTALL - PLEASE PRESS PLAY, STOP
CANCEL" is displayed.
2
Press ÉÅ on the system to start installation.
➜ "PLUG AND PLAY" .... "INSTALL" is
displayed, followed by "TUNER" and "AUTO".
➜
starts flashing.
PROG
➜
The system will automatically store the radio
stations (FM only ) with sufficient signal strength.
➜
When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station will be played.
(for tuner installlation)

Basic Functions

To reinstall Plug and Play
1
In standby mode, press and holdÉÅ on the
system until "AUTO INSTALL - PLEASE
PRESS PLAY, STOP CANCEL" is displayed.
2
Press ÉÅ again to start installation.
➜
All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
● Press 9 on the system.
➜
If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
Notes:
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" will be displayed.
15