Table of Contents
Advertisement
FOR HOMES WITH SIGNIFICANT NEWLY INSTALLED COPPER PIPES PRIOR TO THE
ECOTAC™ UNIT, IT IS RECOMMENDED THAT INSTALLATION OF THE SYSTEM BE
POSTPONED FOR 3-4 WEEKS TO ALLOW A PROTECTIVE COATING TO FORM ON THE
NEW COPPER PIPES.
Minimum Water Pressure
20 PSI
Maximum Water Pressure
90 PSI*
Recommended Water Pressure
40-70 PSI
Water Temperature
36F to 100F (2 to 38C)
Minimum Air Temperature
32°F (0°C)**
pH Range
6.5*** to 8.5
Maximum Service Flow Rate
15 GPM (57 LPM)
Recommended Service Flow Rate
<10 GPM (37 LPM)
Water Supply
Treated City Water
* While the ecoPLUS™ system is built to withstand pressures exceeding 90 PSI, if your water
pressure is greater than 70 PSI, we recommend that you have a certified plumber install a
pressure reducing valve ahead of the ecoPLUS ™ system.
** The system cannot be subjected to freezing conditions or severe damage to the system
and your property could occur.
*** pH correction is strongly recommended where pH levels are less than 6.5 to prevent
damage to your plumbing system, and to prevent the leaching of metals from copper and
brass plumbing components and solder in your home. Contact your dealer for
recommendations.
INSTALLATION
WE RECOMMEND THAT YOU READ THIS ENTIRE MANUAL BEFORE STARTING THE
ACTUAL INSTALLATION. WHILE WE STRONGLY RECOMMEND THAT A LICENSED
PLUMBER PERFORM ALL INSTALLATION WORK, A MECHANICALLY-INCLINED
6
Advertisement
Table of Contents
