Table of Contents
Advertisement
6. Lubricate the O-ring with food-grade silicon lubricant if needed. Insert O-ring in the
groove at the top of the sump and press into place. Make sure the O-ring is seated
level in the groove!
7. Remove the protective plastic wrapping from the new filter cartridge and insert the
cartridge into the housing sump, making sure that it slips over the standpipe in the
bottom of the housing.
8. Screw the sump onto the housing cap and hand tighten. Do not use the spanner
wrench and do not over-tighten.
9. Turn the bypass valve on the media tank back to the service position. Turn on the
water supply slowly to allow the system to fill with water. Inspect carefully for leaks.
If a leak is found, first inspect the O-ring to ensure that it is seated properly before
tightening the sump more.
10. Flush the system by running water from a nearby faucet for 5 minutes. .
Media Replacement
The media in you ecoPLUS™ system and ecoTAC filter are designed for a life of 5 years or
1,000,000 gallons, whichever comes first.
The replacement media kit for your ecoPLUS™ filter is: EP-1000-R
The replacement media for your ecoTAC™ filter is: ScaleStop (5L)
Detailed media replacement instructions are provided with the replacement media kit.
VALIDATIONS
Only the best components go into our ecoPLUS™ water treatment systems. They are
sourced from some of the leading manufacturers in the business, and assembled at our
factory in Canada. You can be assured that only the finest materials have gone into the
manufacture of all ecoPLUS™ systems and that the materials used are safe for potable water
contact. The following is a list of key system components:
Component
Valve & Bypass Assembly
Manufacturer
Clack Corporation
Windsor, WI, USA
Made in USA
Material Safety Validations
NSF/ANSI Standard 44
NSF/ANSI Standard 372
26
Advertisement
Table of Contents
