Cooper Security 726r - Hand Held PA Manual

Also See for 726r:

Manual (44 pages)

Table of Contents

Contents

1 Introduction
2 Overview
3 Compatible Equipment
4 Learning
5 Testing
6 Specification
7 Service
8 Documents / Resources
- 8.1 Download manual

Cooper Security 726r - Hand Held PA Manual

Introduction

The 726r is a dedicated wirefree PA. The unit is supplied in two variants: -60 without aerial and -50 with aerial. The -50 variant has a higher range. The figure below shows the controls available on the -60 variant. The controls on the -50 variant are the same.

To activate the PA the user presses the two orange keys together. A third black key allows the user to lock one of the orange keys in the off position, making the unit safe to carry in a pocket. The RFX can use up to six 726rs.

Overview

Activity LED.
Orange keys.
Black lock key.

Compatible Equipment

762r	Two channel receiver
768r/769r	8 channel receiver
790rEUR-00	Signal Strength Meter.
7500r	Domestic Radio Panel

Learning

See instructions in the appropriate Installation and Programming Guide for the receiver.

Testing

Put the control unit into engineer walk test.
Hold the detector in place.
Trigger the unit.
Make sure the panel receives the alarm.
Check that the control unit can receive the signal from the PA across the whole site.
Put the control unit back into user mode when you have finished testing.

Specification

Part No.	726rEUR-60 (without aerial) 726rEUR-50 (with aerial).
Power Supply	Lithium cell.
Temp. Range	-10 to +55°C.
Power Supply	Lithium cell permanently soldered in. Return to Cooper Security Service Department for replacement.
Battery Life	3 to 5 years.

Service

The battery is permanently soldered in place on the PA's circuit board. When the battery fails return the unit to the manufacturer. If the transmitter shows a pulsing glow from the activity LED for 30 seconds then a fault has occurred. Return the unit to your supplier.