Preparation Before Operation; Installing The Remote Controller Batteries; Setting Current Time - Mitsubishi Electric MSZ-AP35VGK Operating Instructions Manual

● OPERATING INSTRUCTIONS ●
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or
turn the breaker on.

Installing the remote controller batteries

4.
Press RESET.
1.
Remove the front lid.
EN
Note:
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• The battery replacement indicator lights up when the battery is running low.
In about 7 days after the indicator starts lights up, the remote controller stops
working.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with ex-
pired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
EN-5
2.
Insert the negative
pole of AAA alkaline
batteries fi rst.
3.
Install the front lid.

Setting current time

1.
Press CLOCK.
4.
Press CLOCK again.
Note:
• Press CLOCK gently using a thin instrument.
Note:
How to set remote controller exclusively for a particular indoor unit
A maximum of 4 indoor units with wireless remote controllers can be used in
a room.
To operate the indoor units individually with each remote controller, assign a
number to each remote controller according to the number of the indoor unit.
This setting can be set only when all the following conditions are met:
• The remote controller is powered OFF.
(1) Hold down button on the remote controller for 2 seconds to enter the
pairing mode.
(2) Press button again and assign a number to each remote controller.
Each press of button advances the number in the following order: 1 →
2 → 3 → 4.
(3) Press button to complete the pairing setting.
After you turn the breaker ON, the remote controller that fi rst sends a signal
to an indoor unit will be regarded as the remote controller for the indoor unit.
Once they are set, the indoor unit will only receive the signal from the as-
signed remote controller afterwards.
3.
Press the DAY button
to set the day.
2.
Press either the TIME button
or the TIMER buttons to set
the time.
Each press changes the clock
1 minute forward/backward (10
minutes when pressed longer).