Cleaning The Trimmer - Panasonic ER-GK60 Operating Instructions Manual

Cleaning the trimmer

• Clean the trimmer and the blade after each use.
(If not cleaned, the motion will become poor and the sharpness
will worsen.)
• Make sure that the trimmer is turned off.
1. Remove the trimmer from the AC adaptor.
To remove light dirt
2. Remove the attachment and
turn the trimmer on.
3. Run water down the water
inlet at the back of the main
body, rinse thoroughly for
approximately 20 seconds,
and then turn the trimmer
off.
• Rinse with water and
shake up and down
several times to remove
the water.
12
PB014365 - ER-GK60 _(01EN)_02-21-17.indd 12
To remove heavy dirt
2. Remove the attachment and
blade.
3. Clean the trimmer, the blade
and the attachments with
running water.
• Rinse with water and
shake up and down
several times to remove
the water.
4. Wipe off the water with a towel and
let it dry naturally.
• It will dry faster with the blade
removed.
5. Apply the oil to the blade after
drying. (See this page.)
Cleaning with the brush
• Remove the blade. (See this page.)
1. Brush off any hair trimmings from the
main body and from around the blade.
2. Brush off the hairs from the blade edge.
3. Brush any hair trimmings out from
between the stationary blade and the
moving blade while pressing down the
cleaning lever ( ) to raise the moving
blade.
4. Apply the oil to the blade. (See this page.)
Cleaning the AC adaptor
Use the cleaning brush to clean hair trimmings and dust in the
charging plug or in the hole on the bottom surface.
2017/2/21 17:20:18