Cleaning The Trimmer - Panasonic ER-GK60 Operating Instructions Manual

Cleaning the trimmer

• Clean the trimmer and the blade after each use.
(If not cleaned, the motion will become poor and the sharpness
will worsen.)
• Make sure that the trimmer is turned off.
• Remove the trimmer from the AC adaptor.
►With water
Main body, blade and the attachment
To remove light dirt
1. Remove the attachment and
turn the trimmer on.
2. Run water down the water
inlet at the back of the main
body, rinse thoroughly for
approximately 20 seconds,
and then turn the trimmer
off.
• Rinse with water and
shake up and down
several times to remove
the water.
• Be careful not to hit the main body on the sink or any other
object while draining the water. Failure to do so may cause
malfunction.
12
To remove heavy dirt
1. Remove the attachment and
blade.
2. Clean the trimmer, the blade
and the attachments with
running water.
• Rinse with water and
shake up and down
several times to remove
the water.
3. Wipe off the water with a towel and
let it dry naturally.
• It will dry faster with the blade
removed.
4. Apply the oil to the blade after
drying. (See page 13.)
5. Attach the attachment and the
blade to the main body.
►With the brush
Main body and blade
• Remove the blade. (See page 13.)
1. Brush off any hair trimmings from the
main body and from around the blade.
2. Brush off the hairs from the blade edge.
3. Brush any hair trimmings out from
between the stationary blade and the
moving blade while pressing down the
cleaning lever ( ) to raise the moving
b
blade.
4. Apply the oil to the blade. (See page 13.)
5. Attach the attachment and the blade to the main body.
AC adaptor
Use the cleaning brush to clean hair trimmings and dust in the
charging plug or in the hole on the bottom surface.
b