Operation
The ProTwin allows the dilution of chemical products with water without using
an electrical or other power source. The only energy required is the pressure
of the water passing through a venturi which aspirates a metered chemical
into the flow of water through the venturi.
When the installation is properly completed,follow these steps:
1. Turn on the water supply
2. Select the desired cleaning phase
- Selector facing up "OFF"
- Selector facing right "PRODUCT N° 1"
- Selector facing down "RINSE"
- Selector facing left "PRODUCT N° 2"
3. Activate the spray gun
4. Shut off the water supply when not in use
0000137791
Rev. 4.0
EN
6
Need help?
Do you have a question about the ProTwin and is the answer not in the manual?