Technical Characteristics - Seko ProTwin Installation Manual

TECHNICAL CHARACTERISTICS:

Water supply
connection
Inlet connection type
Outlet connection type Male ¾" GHT
Chemical product
channel flow rate
Rinse channel flow rate Water supply of 8gal/min at 45psi: 4.2 gal/min
Maximum dimensions
Working pressure
Temperature
Ü
PLEASE READ THE FOLLOWING WARNINGS BEFORE INSTALLING OR SERVICING THE
CLEANING STATION
§ Make sure that the water supply pressure is between 22 -85 PSI, in case of excessive pressure use a
pressure regulator to avoid breackage.
§ Make sure that the water supply temperature does not exceed 140° (60°C)
§ The ProTwin's fittings have been tested with commonly used liquid detergents mixed with water.
§ Check that the detergent used is compatible with polypropylene.
§ Install the station near as possible to a water supply connection point.
§ Mount the ProTwin considering easy access for cleaning and routine maintenance.
I
WARNING: Disconnect water supply before servicing the ProTwin.
I
WARNING: Follow common safety procedures. Use adequate protection for the eyes, face, hands,
and clothing.
Ü
We constantly work to improve our products and reserve the right to make changes at any time
without prior notice.
Ü
Failure to follow these safety precautions may cause personal injury or damage to the equipment.
Ü
Only use recommended accessories.
0000137791
Connection on left side with elbow
Male ¾" GHT
Water supply of 8gal/min flow rate and 45psi: 2.4 gal/min
H = 15.75"
Min 22 PSI
Optimum: 30 – 60 PSI
Max 140°F (60°C)
Rev. 4.0 EN
L = 13" D = 6.3"
Max 85 PSI
2