Samsung RB30J3 Series User Manual page 29

15. Switch the position of Bottom hinge and Leg.
(Right -> Left)
Assemble the Hinge Low after putting the
Freezer Door in the middle hinge.
• Disassemble the Guide auto close and the
Shaft-hinge.
• Assemble the Shaft-hinge and the the Guide
auto close like this on picture.
Hinge Leg
16. Put the Cap-Control out from the Cover Control
like the picture (1).
Remove the Screw and disassemble the Cover
control (2), Switch the Wire door (3) direction
to opposite side on Fridge Door (Door Display
type only).
Assemble the Cover-Control with Screw like a
Picture (4).
(1)
(2)
(3)
(4)
DA68-02833Q-18.indb 29
Shaft-hinge
(1-1) (1-2)
(1-3) (1-4)
(1-5)
17. Switch the Wire-Door Direction to opposite
side like the Picture.
18. Use 11 mm wrench to separate the Top hinge
shaft.
Flip the Top hinge and reattach the Top hinge
shaft.
18-1. Use 11 mm wrench to separate the Top
hinge shaft and nut.
Flip the Top hinge and reattach the Top
hinge shaft and nut. (Only for RB33N*,
RB34N*, RL33N* model)
Tighten the shaft (and nut) as much as
possible using a wrench.
19. Insert the Top hinge to make the hole a little
bigger and then put out the Top hinge to
assemble the Fridge door.
Assembly steps
1. Assemble the Top hinge on the Fridge door.
2. Assemble the Middle hinge on the Fridge door.
3. Insert the Top Hinge on the Cabinet.
4. Assemble the screw.
operating _29
2018. 2. 2. 9:16