Chamberlain CWA2000C Operation Instructions

Overview
The Wireless Motion Detection System uses a Passive Infra-Red (PIR) Motion Sensor to detect movement of people and vehicles.
The Base Station is powered by the DC adapter and the 4 AA batteries supply power in case of a power outage.
NOTE: The Base Station is intended for indoor use only.
WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer
or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
Carton Inventory
Base Station
Operation and Features
BASE STATION
Antenna
Volume
On/Off: To turn the Base Station on and off, hold down the
power button until you hear the on/off tone.
Volume: The Base Station is equipped with adjustable
volume controls. The lowest volume setting is the mute
feature.
DC Adapter
(9 Vdc @ 200mA) Motion Sensor
On/Off Button
Wireless Motion Detection System
Swivel bushing
Rubber Pads
Batteries: If the Base Station batteries are low, the Base
Station will beep every 30 minutes. The AA batteries
in the Motion Sensor will last up to 2 years depending
on use (Lithium batteries are recommended for colder
environments). If the Motion Sensor batteries are low, the
Base Station will beep every 30 minutes until the batteries
are replaced. The Motion Sensor will continue to operate
with a low battery, however the light will not illuminate. For
peak performance, inspect batteries annually and replace as
needed.
Programming Additional Motion Sensors: The Base Station
can learn the code of up to 7 additional Motion Sensors,
responding with unique buzzes. To program additional
Motion Sensors see Step 4.
To order additional Motion Sensors call 1-800-528-9131.
Clear Memory: Press and hold the Learn Button on the Base
Station until 3 beeps are heard.
1
Models CWA2000 and CWA2000C
Sun/Rain Shield Mounting Plate