Advertisement
WARNING:
!
Know your multi-purpose
sharpener. Do not plug in the tool until you
have read and understand this Instruction
Manual.
Learn the tool's applications and limitations,
as well as the specific potential hazards
related to this tool. Following this rule will
reduce the risk of electric shock, fire, or serious
injury.
Always wear eye protection. Any
power tool can throw foreign
objects into your eyes and cause
permanent eye damage.
ALWAYS wear safety goggles (not glasses) that
comply with ANSI safety standard Z87.1.
Everyday glasses have only impact resistant
lenses. They ARE NOT safety glasses.
.
1. Always remove the power cord from the power
source before making 1. Always remove the
power cord from the power source before making
any adjustments or maintenance, including
changing the wheel.
2. Always turn the sharpener off when it is not in
use and never leave it unattended without first
switching off and unplugging power cord. Never
leave the sharpener until the wheel has come to a
complete stop.
3. Do not use a wheel that has received a blow,
especially to the side of the wheel. Replace a
cracked or suspect wheel.
4. Always allow a new wheel to run for a few
minutes at full speed before using it.
5. Check that the wheel rotates freely before each
start up.
6. Do not use the sharpener unless all the
attachments are properly fitted and secure.
7. Do not overload the sharpener. Allow the
sharpener to run at full speed before use.
8. Never apply excessive pressure to the wheel. It
might shatter causing personal injury.
9. Make sure the wheel is not in contact with the
work when you start the sharpener.
10. When using the sharpener, use safety
equipment including safety goggles or shield, ear
protection, dust mask and protective clothing
including safety gloves.
11. Abrasive grinding wheels should be stored
and handled with care in compliance with the
manufacturer's instructions.
12. Examine the grinding wheel before use; do
not use chipped, cracked or otherwise deficient
products.
13. Use only grinding wheels reinforced with
organic bond (80m/s)
14. Make sure that the abrasive product is
correctly mounted and clamped before use.
15.Avoid use in the presence of flammable
materials or substances. Sparks created by
the tool may ignite them.
16. Make sure air vents are unobstructed and
cleaned of dust.
17. Grinding wheels continue to rotate after the
motor stops.
18. If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent, or similarly qualified persons.
19. When servicing use only identical
replacement parts
20.To reduce the risk of electric shock, this
equipment has a polarized plug (one blade is
wider than the other). This plug will fit in a
polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician
to install the proper outlet. Do not change the
plug in any way
21. Do not operate this tool in a damp location.
Do not apply water to tool.
Advertisement
