Advertisement
2.
Open the
positioning
3.
Insert the drill bit into the Drill Bit Holder. Ensure the drill bit tip is in contact with the
Internal Positioning Pad. Pull up on the Plunger to close the Positioning Claws. Tighten
the Drill Bit Holder enough to hold the bit in place but still allow the bit inserted inside to
rotate. Rotate the drill bit inside the holder and ensure the claws meet the surface of the
drill bit when the bit is rotated. Turn the Drill Bit Holder clockwise to lock the drill bit into
place. (Fig.7).
claws by pushing down on the plunger (Fig.6)
Plunger
(Fig.6)
Plunger
Internal
positioning pad
Positioning Claws
(Fig. 7)
Advertisement
