LG Pro:Centric 55UV970H Setup Manual page 62

IP Environment Setup (Cont.)
(Continued from previous page)
3. Refer to the appropriate subsection(s) below to configure the TV's
Pro:Centric settings to match those of the Pro:Centric server.
While the Pro:Centric application itself is an additional feature (see
step 4), the appropriate Pro:Centric server configuration must be
completed to enable TV E-Z Installation (splash screen, configuration,
and software/firmware) data downloads and, if configured, the
Pro:Centric application download.
RF Configuration
For TVs in Pass-through Mode or FTG Mode via CPU, if the Data
Channel is left at its default value (AUTO), the TV's Data Channel Auto
Search feature will be enabled. See Installer Menu item 119 DATA
CHANNEL description on page 14 for further information.
To change the Data Channel setting, select/highlight the Data Channel
field and press OK on the Installer Remote. Then, use the Up/Down
arrow keys to select either MANUAL or AUTO from the drop-down list
of options.
When the Data Channel field is set to "MANUAL," a data entry field is
available on the screen, and you can specify the RF channel number
that will be used by the Pro:Centric server as its data channel. The
Data Channel value can be set from 0 (disabled) to 135.
arrow keys on the Installer Remote to select the Data Channel data
entry field and press OK. You can then use the number keys on the
Installer Remote to direct enter the Data Channel, or you can use the
arrow keys to select the appropriate number(s) from the pop-up virtual
keyboard displayed at the bottom of the screen. When you are done,
select Enter from the virtual keyboard, and then press OK on the
Installer Remote.
Note: If the Data Channel has already been set in the Installer Menu
(Installer Menu item 119) or in the EZ-Manager Wizard, the specified
channel will appear in the Data Channel data entry field. If you change
the Data Channel in this menu, Installer Menu item 119 will now show
the value you entered here.
IP Configuration
Note: If the server IP address and port number or domain name have
already been set in the EZ-Manager Wizard, the specified data will be
reflected in the fields displayed.
Note: Setting the Media Type to "IP" automatically sets item 119 DATA
CHANNEL in the Installer Menu to 253. You cannot alter this setting
unless you revert Media Type to "RF." Also, it is not possible to direct
enter "253" in the Installer Menu.
*
PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
62
* Use the
PRO:CENTRIC
Network
Pro:Centric
Mode
^
Configuration Only
Media Share Update Event
^
Disable
Media Type
^
Pre-loaded RF
Apps
Data Channel
^
AUTO
Note: By default, the Pro:Centric Menu
initially shows RF configuration fields.
When "IP" is selected as the Media Type,
Server Address and either IP Address
and Port Number or Domain Name and
Port Number fields appear on the screen
(in place of the Data Channel field).
(Continued on next page)
206-4327