Sony SRS-X55 Help Manual page 73

If no ring tone is heard via the speaker
The speaker may not be connected with a BLUETOOTH mobile phone with HFP or HSP. Check the connection
status on the BLUETOOTH mobile phone.
Switch the call device to the speaker by pressing and holding the
3. Adjust the volume by tapping the VOL (volume) –/+ buttons on the speaker or operating the BLUETOOTH mobile
phone.
When you tap the VOL (volume) –/+ buttons on the speaker or adjust the volume on the BLUETOOTH mobile
phone, the (power) indicator flashes once in green.
When you set the volume to the maximum or minimum, the
4. To end a call, press the
If you were listening to music before the call, playback will resume when the call ends.
If you end a call by operating the BLUETOOTH mobile phone, playback will also resume when the call ends if you
were listening to music before the call.
Hint
Some BLUETOOTH mobile phones have handset use priority when receiving a call. In the case of the HFP or HSP
connection, switch the call device to the speaker by pressing and holding the
or operating your BLUETOOTH mobile phone.
The volume of music playback and calling is set independently in the speaker.
If the caller cannot hear or can barely hear your voice, talk more directly into the microphone of the speaker.
Note
The sound is output from the right speaker only during a call.
Depending on the BLUETOOTH mobile phone, playback may not pause when an incoming call arrives.
(call) button.
(call) button for about two seconds.
(power) indicator flashes three times in green.
(call) button for about two seconds
69