Applicability: Product with connected domestic hot
water cylinder
▶
Open the cold water stop valve.
4.6 Starting up the product
▶
Only start up the product once the cas-
ing has been completely closed.
4.7 Switching on the product
▶
Switch on the product via the main
switch installed on-site.
4.8 Setting the heating flow
temperature
1. Press
( ).
◁
The target value of the heating flow
temperature appears on the display.
Note
The competent person may
have adjusted the maximum
possible temperature.
Conditions: No controller connected
▶
Use
or
to set the required heating
flow temperature.
▶
Confirm by pressing
Conditions: Controller connected
▶
Set the maximum possible heating flow
temperature on the product.
▶
Confirm by pressing
▶
Set the required heating flow temperat-
ure on the controller (→ Controller oper-
ating instructions).
0020230534_02 ecoFIT pure Operating instructions
4.9 Setting the hot water
1. Press
Conditions: No controller connected
▶
▶
Conditions: Controller connected
.
▶
▶
▶
.
4.10 Switching off the product's
4.10.1 Switching off heating mode
1. To switch off heating mode without
2. Use the
temperature
Warning.
Risk of being scalded by hot
water.
To protect against Legionella,
the hot water can be heated up
to above 60 °C at pre-defined
times.
▶
Have a competent person
inform you about the meas-
ures that should be taken to
protect against Legionella in
your system.
(
).
◁
The set hot water temperature
flashes in the display.
Change the hot water temperature by
pressing
or
.
Confirm by pressing
Use
to set the maximum possible hot
water temperature on the product.
Confirm by pressing
Set the required hot water temperature
on the controller (→ Controller operating
instructions).
functions
(Summer mode)
switching off the hot water generation,
press
( ).
◁
The value of the heating flow tem-
perature appears in the display.
button to set the heating
flow temperature to Off.
Operation 4
.
.
11