Table of Contents
Advertisement
When the unit is no longer going
to be used, do not leave it lying
around, but be absolutely sure to
dispose of it properly.
When installing, transferring or
disposing of the unit, be
absolutely sure to hold it by its
pedestal area.
Problems may result if the camera head is
held or rotated.
Do not attach a filter, hood,
extender or other parts to the
unit.
Use the dedicated AC adaptor
and power cable provided with
the unit.
Connect the AC adaptor and power cable to
the power inlet securely.
Installing the AC adaptor
Do not place the adaptor directly onto a
ceiling panel or other such surface.
Extreme danger is posed when water has
collected on the surface as a result of
leaking rain, for instance.
Secure the adaptor firmly to the bottom or
other surface of a reinforcing member
made of channel steel where dust and
other foreign matter will not accumulate.
(Refer to page 20.)
Secure the adaptor firmly so that there
will be no chance that it will fall off or fall
down.
Secure it using a strength which can
withstand the mass of the AC adaptor.
Power switch
This unit does not have a power switch.
Before proceeding with maintenance, be
absolutely sure to disconnect the power plug
from the power outlet.
[Note]
Under factory default conditions, the unit
will be in Power ON mode when power is
supplied for the first time. (Status display
lamp: Lit green).
When the power supply is cut off while
the unit is in Standby mode, the unit will
be in Standby mode the next time power
is supplied. (Status display lamp: Lit
orange)
When the power supply is cut off while
the unit is in Power ON mode, the unit will
be in Power ON mode the next time
power is supplied. (Status display lamp:
Lit green)
Radio signal interference
If the unit is positioned near a TV or radio
transmitting antenna or a strong electrical
field or magnetic field (such as that
generated by a motor, transformer or power
lines), its images may be distorted and/ or
the images may be affected by noise.
Allowing the generated heat to
escape
This unit allows the heat generated inside to
escape from its surfaces.
Do not install the unit in a location where it
will be surrounded by walls or other surfaces
and where heat will be trapped.
In addition, the heat is dissipated to the
bottom panel which will warm up over time:
This is normal and not indicative of any
trouble.
11
Advertisement
Table of Contents
