Download Print this page

AquaticLife 540565 Installation, Operation, Maintenance Manual

Advertisement

Quick Links

Deionized Spot-Free Car Rinse 2x10
Installation, Operation & Maintenance Guide
OVERVIEW
Water quality is often measured by the amount
of total dissolved solids (TDS) in the water.
It is the TDS in the water that leaves spots
on a vehicle when the water evaporates. By
removing the TDS, a spot-free rinse is achieved.
Removing TDS is accomplished by filtering
the water through a resin that is charged with
Cation and Anion resins (H+ and OH-). As the
resin absorbs the TDS, it will change color.
When the entire resin has changed color,
it is time to replace the DI cartridge.
How Resin Works
OPERATING GUIDELINES
The maximum incoming water pressure for
the unit is 80 PSI. If the pressure is more than
80 PSI, a pressure regulator is required.
Deionized water should not be run through
a copper tube. The pure DI water can leach
copper from the pipe, eventually leading to
holes in the pipe.
DO NOT pressurize and operate the
unit unattended.
NOTE:
Filter cartridge life will vary based
on local water conditions & amount of use.
For technical assistance or
warranty issues, contact Aquatic Life at
customersupport@aquaticlife.com
Thank you for
purchasing an
Aquatic Life
Deionized Spot-Free
Car Rinse Unit.
When maintained
properly, this unit
will provide you with
years of high-quality
filtered water.
Model# 540565
HOW TO USE
Failure to follow these
steps will deplete your
cartridges quickly and
cost you extra money.
Follow these simple
steps for best results:
The spot-free rinse is what is important
to ensure spots do not form on the vehicle.
DO NOT use the spot-free rinse for steps 1-3.
Recommended Installation Tools
Adjustable Wrench
Contents (Model #540565)
Dual DI Unit Housing
1
with Mounting Bracket
1 Plumber's Pipe Tape
Brass ½" MPT x Female
1
Garden Hose Adapter
Brass ½" MPT x Male
1
Garden Hose Adapter
2 ½" Rubber Washers
Installation Instructions
Phillips Screwdriver
Color-changing
2
Deionization Cartridges
1 Canister Wrench
Installation, Operation &
1
Maintenance Guide
1 Misting Nozzle
1 ¾" Rubber Washer

Advertisement

loading

Summary of Contents for AquaticLife 540565

  • Page 1 The maximum incoming water pressure for Adjustable Wrench Phillips Screwdriver the unit is 80 PSI. If the pressure is more than Contents (Model #540565) 80 PSI, a pressure regulator is required. Deionized water should not be run through Dual DI Unit Housing Color-changing a copper tube.
  • Page 2 Model# 540565 Deionized Spot-Free Car Rinse 2x10 Installation, Operation & Maintenance Guide www.aquaticlife.com INSTALL THE ADAPTERS MOUNTING THE UNIT HOSE INSTALLATION UNIT MAINTENANCE Use a hose with standard garden hose threads The deionization cartridges are designed Step 1 – Apply three wraps of the pipe tape to...
  • Page 3 United States or electronic mail to the following address: U.S. Mail: Lifetime Products, LLC, 9710 Klingerman St., S. El Monte, 200 TDS, your DI cartridge will last two CA 91733 or electronic mail: customersupport@aquaticlife. times longer than your neighbors. com. Lifetime Products shall be allowed a reasonable period...