Edimax BR-6428nS V4 User Manual page 151

Router Login
Username/Password This is the default username and password to
Wi-Fi Network
Name
MAC
PIN CODE
5. I forgot my password.
a. Reset the router to its factory default settings and use the default username
admin and default password 1234. Default settings are displayed on the product
label on the back of the device, as shown above.
6. My BR-6428nS V4 has a weak wireless signal in range extender
mode.
a. Weak signals are usually caused by interference from other devices or obstacles
blocking the BR-6428nS V4's wireless signal:
b. Keep the device away from other radio devices such as microwaves or wireless
telephones.
c. Do not put the device in the corner of a room or under/nearby metal.
d. Ensure there are as few obstacles as possible between the BR-6428nS V4 and
your wireless network device.
In range extender mode, the BR-6428nS V4'S weak wireless signal may be in turn
caused by a weak signal from your existing router. It's important to choose a good
location for the BR-6428nS V4 in relation to your existing wireless router. The best
location is roughly in the middle between your existing wireless router and the area
you would like to be covered by the BR-6428nS V4. If you are too far away from
your existing router, then it is difficult for the BR-6428nS V4 to receive a wireless
signal.
Enter this URL in a web browser to run iQ Setup or
configure advanced settings. You must be
connected to the device by Wi-Fi or Ethernet
cable.
access the browser based configuration interface
when you go to the "Router Login" URL (above).
This is the default Wi-Fi network name for the
device. Search for this name (SSID) and connect to
it in order to access the "Router Login" URL
(above).
A MAC address is unique to every device and is
used for identification within a network. Your
device's unique MAC address is displayed here.
This is your device's PIN code for Wi-Fi Protected
Setup (WPS).
147