Table of Contents
Advertisement
7 Place the fan cover back and gently press the cover until you hear a click sound.
To confirm that your FS2500 recognizes the new memory capacity
1 Install DiskStation Manager (DSM). Please see "Install DSM on Synology NAS" for more information.
2 Sign in to DSM as admin or a user belonging to the administrators group.
3 Go to
Control Panel
>
Info Center
and check
Total Physical
Memory.
If your Synology NAS does not recognize the memory or does not start up successfully, please make sure that
the memory module is installed correctly.
To remove the RAM Module
1 Follow step 1 to 3 of the "To install the RAM module" section to shut down your FS2500, disconnect the
cables, and then remove the rear top cover as described above.
2 Push the retaining clips on the slot out to the sides. The memory module will pop out of the slot.
3 Follow step 6 to 7 of the "To install the RAM module" section to fasted the top cover back in place.
17 Chapter 2: Hardware Setup
Advertisement
Table of Contents
