Advertisement
3. Install a receiver assembly in the hole (Figure 2).
1. Hex-head bolt (1/4 x 3/4 inch)
2. Receiver assembly
4. Secure the receiver to the bed with the 2 hex-head bolts (1/4 x 3/4 inch) and 2 locknuts (1/4 inch).
Note: Tighten the locknuts until snug, but do not overtighten.
Installing the Stake Pocket Adapters (for 2014 Models and
Newer)
1. Install a receiver assembly into the hole (Figure 3).
2. Secure the receiver to the bed with 2 hex-head screws (1/4 x 3/4 inch) as shown in Figure 3.
Important: Torque the hex-head screws (1/4 x 3/4 inch) to 4 to 5 N-m (35 to 45 in-lb), or the threads on
the screws may be damaged.
1. Hex-head screw (1/4 x 3/4 inch)
1
2
3
4
Figure 2
3. Drilled holes
4. Locknut (1/4 inch)
Figure 3
2. Receiver assembly
2
G014776
Advertisement
