Fault
Appliance stops dur-
ing the programme or
cuts out.
All LEDs lit up or
flashing.
Appliance door can-
not be closed.
Lid on the detergent
dispenser cannot be
closed.
Filling valves making
knocking noises.
Cause and troubleshooting
Top basket is pressing against inner door and pre-
venting appliance door from being closed securely.
Check whether the rear panel of the appliance is
▶
being pressed in by a socket or hose holder that
has not been removed.
Arrange the tableware so that no parts project bey-
▶
ond the basket and prevent the appliance door
from closing properly.
Electronics have detected a fault.
Press the main switch button for approx.
1.
4 seconds.
The appliance is reset and restarted.
If the problem occurs again:
2.
Switch off the appliance.
‒
Pull out the mains plug or switch off the fuse in
‒
the fuse box.
Wait at least 2 minutes.
‒
Switch on the fuse in the fuse box or insert the
‒
mains plug.
Switch the appliance on.
‒
If the problem occurs again:
3.
Contact customer service.
‒
→ "Customer Service", Page 66
Door lock has been activated.
Close the appliance door with greater force.
▶
Door cannot be closed due to installation method.
Check whether the appliance has been installed
▶
properly.
When closed, the appliance door, its decor or at-
tached parts should not knock against adjacent
cabinets or the worktop.
Automatic door opening is not in home position.
Wait for a second after opening the appliance door.
▶
Detergent dispenser or lid are blocked by sticky deter-
gent residue.
Remove detergent residue.
▶
Caused by the domestic installation. No appliance
fault present. Does not affect functioning of the appli-
ance.
Can only be remedied in the domestic installation.
▶
Troubleshooting en
63