Table of Contents
Advertisement
Chapter 1
Introduction
PWR LED
ETH/PWR Port
Chassis Ground Connection
Section 1.3
Required Tools and Materials
The following tools and materials are required to install the RUGGEDCOM WIN5118:
Kits
• Class I, Division 2 Kit (P/N MKIT0090) – For hazardous
locations only
Tools
• Wrench or socket set
• Phillips screwdriver
• Drill with an 8 mm (5/16 in) drill bit
• Wall anchors (if necessary)
Sprays
• Cleaner and de-greaser
• SCC3 conformal coating
• Corrosion protection
Section 1.4
Decommissioning and Disposal
Proper decomissioning and disposal of this device is important to prevent malicious users from obtaining
proprietary information and to protect the environment.
4
State
Green (Solid)
Green (Blinking)
Indicates when power is supplied to the subscriber unit.
State
Green
Off
A copper RJ45 PoE port for data and power. For more information about connecting data and
power, refer to
Section 2.8, "Connecting Power and
Protects the subscriber unit from power surges and accumulated static electricity. For
information about grounding the subscriber unit, refer to
Subscriber
Unit".
Greases
• Marine grease (for marine applications only)
Tapes
• POE cold shrink (maximum 49.2 mm or 1.9 in inner
diameter before shrinking) or self-amalgamating tape
• UV-resistant vinyl tape
• Electrical insulation putty
Mounting Hardware (Wall/Tower Only)
• Four 1/4" × 1/2" HEX chipboard screws
• Four 1/4" flat washers
• Four 1/4" spring washers
RUGGEDCOM WIN5118
Installation Guide
Description
Subscriber unit is connected to the base
station and receiving services.
Link between the subscriber unit and the
base station is down.
Description
Power is on.
Power is off.
Data".
Section 2.7, "Grounding the
Required Tools and Materials
Advertisement
Table of Contents
