Advertisement
• Pushing the lever allows liquid spraying from the nozzle as shown in the gure.
If you want intermittent spraying, control the spray by the lever. If you want continuous spraying, use
the f i x i n g ring as shown in the
f i g u r e
• We recommend spraying pressure as following.
a. High pressure spraying - water soluble powder, general chemical, pesticide spraying b.
Low pressure spraying – herbicide spraying, indoor sterilizing
• Please always turn the power switch to OFF after spraying work. If you used pressure control switch, make
sure to turn the switch to the far left to OFF position.
Both the power switch and pressure control switch should be at
Caution
OFF position when not in use.
• We provide with 4 kinds of nozzles. Please use one which f i ts to
your use.
a. Cone nozzle (2 openings)
This nozzle sprays the liquid in circular shape as shown in the f i gure.
The spray particle is fine (small). It is good for pesticide and weed prevention.
Cone nozzle is most generally used because it sprays liquid in most uniform
manner.(Pressure 0.17-0.18Mpa, flow rate 1.6-1.7 L/min)
b. Pan nozzle
This nozzle sprays the liquid in narrow oval shape as shown in the gure. It is
good when spraying on at plane. It is good for herbicide and insect
extermination. We recommend low pressure for herbicide so that the particle
would be bigger; while we recommend high pressure for insecticide so that
the particle would be
c. 4-opening nozzle
smaller.(Pressure 0.16-0.17Mpa, flow rate 1.2-1.3L/min)
Advertisement
