Garland 852 ZG Instruction Manual page 42

English
C. Place the air lever in the Closed position
D. Place the accelerator lever in the maximum
position .
E. Pull the starter grip until the engine starts up and
go past the air lever slowly to the OPEN position
(normal working position). Put the throttle lever
in the down position and let the engine warm for
1 minute before starting to work.
Normal working
position
5.3.4.2. WARM ENGINE START
Follow the A & B steps on the Cold engine start. Move
the throttle to middle position and pull the starter grip
until it starts.
5.3.5. CHECKPOINTS AFTER COMMISSIONING
It is important to pay attention to the possible loose
parts or the temperature of the machine. If you
detect any anomaly in the machine immediately stop
and check it carefully. In case of any malfunction or
problem take the machine for service for repaired.
Under no condition should you continue to use the
. machine if the operation does not seem appropriate.
5.3.5.1. VERIFICATION OF THE SECURITY SYSTEM
Check that the safety system works correctly by a
testing of the machine without a trunk. To do this,
switch on the engine by pressing the switch and
pushing both the hydraulic control levers at the same
time, the blade will begin its cutting motion. While the
blade is moving stop pressing the left lever and blade
should stop and move back to its original position.
Then perform the same test operation.
If after the test you detect that the machine does
not function as described in this point do not reuse
the machine until it has been reviewed by a service
technician.
5.3.5.2. LEAK VERIFICATION
Check that there are no oil leaks in the machine. If you
detect a leak, take your machine in for service.
5.4. STOP THE ENGINE
Throttle level
Move the throttle lever to the down position and the
engine switch OFF. If you put the shredder away,
move the lever to the passage of gasoline in the OFF
purposes. Using this chainsaw for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
Never force the bandsaw for more than 5 seconds
by pressing on a trunk too hard. After this interval,
oil that is under pressure can overheat and damage
the machine. For logs of extreme hardness, turn the
log 90 degrees to try to cut it in another position. If
42/156
6. USING THE MACHINE
Use this machine only for the designated