Garland 852 ZG Instruction Manual page 30

English
recommend you practice doing a simple job and, if
possible, in the company of an experienced person.
The cutting tool of this machine is very sharp. It is
dangerous to use this machine improperly.
Warning! Only lend this machine to persons who
are familiar with this type of machine and know how
to use it. Always lend the machine along with the user
instruction manual so the new user can carefully read
it and understand it.
This machine is dangerous in the hands of untrained
users.
2.2. PERSONAL SAFETY
Stay alert, watch what you are doing and use common
sense when operating this machine.
Do not modify the machine controls or regulations of
the engine speed.
Avoid accidental starting of the machine. Verify that
the switch is in the "open" position before connecting
the machine to the network. Never carry the machine
with your finger on the switch or with the switch in the
"Closed" position since it may put their safety at risk
and cause accidents.
Do not use this machine when you are tired or under
the influence of drugs, alcohol or medication. A
moment of inattention while operating this machine
can cause serious personal harm.
Do not use this machine if one of its parts is damaged.
Never use the machine with defective guards, or
without safety devices.
Remove all keys or hand tools from the machine and
the work area before starting the machine.
A wrench or tool left near the machine may be
touched by a part of the machine in motion and to
project itself causing personal injury.
Do not exceed yourself. Keep both feet firmly in place
on the ground and maintain balance at all times.
Always maintain proper foot support and operate the
machine only when it is standing on a fixed, secure
and level surface. Slippery or unstable surfaces may
cause a loss of balance or control of the machine.
Keep all parts of body away from cutting elements and
moving parts when the machine is running.
Before starting the machine, make sure that the
cutting element is not in contact with any object. A
moment of carelessness during the performance of
the machine may cause your clothing or other part of
the body to be cut by a cutter from the tool.
If the machine vibrates abnormally, stop the engine,
inspect the machine and look for the possible cause
and repair. If you cannot find the cause of the problem
take the machine to the service technician.
Before leaving the machine unattended turn it off,
wait for the cutter to stop, and disconnect it from the
network.
Store idle tools out of the reach of children.
Do not attempt to charge the bandsaw if the pusher is
not stopped.
Keep hands away from moving parts. Keep your hands
away from the cuts and cracks that open in the trunk
during the cutting operation since they could close
suddenly and crush or amputate your hands.
30/156