Adjusting The Height Of Cut; Adjusting The Anti-Scalp Rollers - Toro TimeCutter MX 5025 Operator's Manual

Adjusting the Height of Cut

Note:
The transport position is the highest
height-of-cut position or cutting height at 115 mm
(4-1/2 inches) as shown in
Height of cut is controlled by the lever located to the
right of the operating position
Figure 22
Figure 22.
(Figure 22).
Adjusting the Anti-Scalp
Rollers
For Machine with 107 cm (42-inch)
Mower Decks Only
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers to 1 of the following
positions:
•
Upper hole—use this position with the mower
deck in the 63 mm (2-1/2 inches) and below
the height-of-cut positions
•
Lower hole—use this position with the mower
deck in the 76 mm (3 inches) and above the
height-of-cut positions
g028025
1. Anti-scalp roller
2. Lower hole—the mower
deck in the 76 mm (3
inches) and above the
height-of-cut positions
3. Flange nut
24
(Figure 23).
(Figure 23).
Figure 23
4. Upper hole—the mower
deck in the 63 mm (2-1/2
inches) and below the
height-of-cut positions
5. Bolt
g019929