Toro TimeCutter MX 5025 Operator's Manual page 14

Park Position
Move the motion-control levers outward from the
center to the P position when exiting the machine
ARK
(Figure 18). Always position the motion-control levers
into the P position when you stop the machine or
ARK
leave it unattended.
Smart Speed™ Control System
Lever
The Smart Speed™ Control-System lever, located
below the operating position, gives you a choice to
drive the machine at 3 speed ranges— trim, tow, and
mow (Figure 21).
Fuel-Presence Window
You can use the fuel window, located on the left side
of the machine, to verify the presence of fuel in the
tank (Figure 6).
1. Fuel-presence window
Figure 6
Height-of-Cut Lever
Use the height-of-cut lever to lower and raise the deck
from the seated position. Moving the lever up (toward
you) raises the deck from the ground and moving the
lever down (away from you) lowers the deck toward
the ground. Adjust the height-of-cut only while the
machine is not moving
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
To best protect your investment and maintain optimal
performance of your Toro equipment, count on Toro
genuine parts. When it comes to reliability, Toro
delivers replacement parts designed to the exact
engineering specification of our equipment. Insist on
Toro genuine parts.
g014521
14
(Figure 22).