Sony HT-DDW660 Operating Instructions Manual page 33

Models of area code AU
(6 ohms 120 Hz – 20 kHz, THD 0.09%)
(6 ohms 100 Hz, THD 0.09%)
(6 ohms 1 kHz, THD 0.7%)
(6 ohms 100 Hz, THD 0.7%)
(6 ohms 1 kHz, THD 10%)
(6 ohms 100 Hz, THD 10%)
1) Measured under the following conditions:
Area code
U, CA, MX
SP
E51, AU
2) Depending on the sound field settings and the
source, there may be no sound output.
Inputs (Analog)
DVD, VIDEO
Inputs (Digital)
DVD (Coaxial)
VIDEO (Optical)
Reproduction frequency range:
Tone
Gain levels
FM tuner section
Tuning range
Antenna
Antenna terminals
Intermediate Frequency
2)
FRONT : 40 W/ch
2)
CENTER : 40 W
2)
SURR : 40 W/ch
2)
SUB WOOFER : 40 W
2)
FRONT : 50 W/ch
2)
CENTER : 50 W
2)
SURR : 50 W/ch
2)
SUB WOOFER : 50 W
2)
FRONT : 70 W/ch
2)
CENTER : 70 W
2)
SURR : 70 W/ch
2)
SUB WOOFER : 70 W
Power requirements
120 V AC, 60 Hz
230 V AC, 50 Hz
240 V AC, 50 Hz
Sensitivity: 800 mV
Impedance: 50 kiloohms
Sensitivity: –
Impedance: 75 ohms
Sensitivity: –
Impedance: –
28 – 20,000 Hz
±6 dB, 1 dB step
87.5 - 108.0 MHz
FM wire antenna
75 ohms, unbalanced
10.7 MHz
AM tuner section
Tuning range
Models of area code U, CA
With 10-kHz tuning scale: 530 - 1,710 kHz
With 9-kHz tuning scale: 531 - 1,710 kHz
Models of area code SP, AU
With 9-kHz tuning scale: 531 - 1,602 kHz
Models of area code MX, E51
With 10-kHz tuning scale: 530 - 1,610 kHz
Antenna
Intermediate Frequency
3) You can change the AM tuning scale to 9 kHz or
10 kHz. After tuning in any AM station, turn off the
receiver. While holding down PRESET TUNING +
or TUNING +, press ?/1. All preset stations will be
erased when you change the tuning scale. To reset
the scale to 10 kHz (or 9 kHz), repeat the procedure.
General
Power requirements
Area code
U, CA, MX
SP
E51
AU
Power consumption
Area code
U
CA
SP, E51, MX, AU
Power consumption (during standby mode)
Dimensions (w/h/d) (Approx.)
Mass (Approx.)
3)
3)
Loop antenna
450 kHz
Power requirements
120 V AC, 60 Hz
220 – 230 V AC,
50/60 Hz
120/220/240 V AC,
50/60 Hz
240 V AC, 50 Hz
Power consumption
150 W
210 VA
150 W
0.3 W
430 × 145 × 301.5 mm
(17 × 5 6/8 × 11 7/8 inches)
including projecting parts
and controls
6.5 kg (14 lb 6 oz)
continued
GB
33