Table of Contents
Advertisement
Hydraulic Lift and Slew System (continued)
• Toro PX Extended Life Hydraulic Fluid (refer to your Authorized Service Dealer for
more information)
• If either of the above Toro fluids are not available, you may use another Universal
Tractor Hydraulic Fluid (UTHF), but they must be only conventional, petroleum-
based products. The specifications must fall within the listed range for all the following
material properties and the fluid should meet the listed industry standards. Check with
your hydraulic fluid supplier to determine if the fluid meets these specifications.
Note:
so use only products from reputable manufacturers who will stand behind their
recommendations.
Material Properties
Viscosity, ASTM D445
Viscosity index, ASTM D2270
Pour Point, ASTM D97
Industry Standards
API GL-4, AGCO Powerfluid 821 XL, Ford New Holland FNHA-2-C-201.00, Kubota UDT, John
Deere J20C, Vickers 35VQ25 and Volvo WB-101/BM
Note:
dye additive for the hydraulic system fluid is available in 20 ml (2/3 fl oz) bottles. One
bottle is sufficient for 15 to 22 L (4 to 6 US gallons) of hydraulic fluid. Order Part No. 44-
2500 from your Authorized Toro Dealer.
Checking the Hydraulic-Fluid Level for the Lift and Slew System
1. Park the machine on a level surface, move the motion-control levers to the N
position, engage the parking brake, rotate and raise the hopper, and install the cylinder
lock.
2. Shut off the machine and remove the key. Allow the machine to cool completely.
3. Remove the filler cap from the reservoir tank.
4. Remove the dipstick
dipstick into the filler neck; then remove it and check the level of the fluid. The fluid level
should be up to the full mark
5. If the level is low, add the specified hydraulic fluid to raise the level to the full mark.
Maintenance: Hydraulic System Maintenance
Toro will not assume responsibility for damage caused by improper substitutions,
Many hydraulic fluids are almost colorless, making it difficult to spot leaks. A red
from the filler neck and wipe it with a clean rag. Insert the
cSt at 40°C: 55 to 62
cSt at 100°C: 9.1 to 9.8
140 to 152
-37 to -43°C (-35 to -46°F)
G375955
on the dipstick.
Page 5–27
-L
EUTRAL
OCK
3462-915 A
Advertisement
Table of Contents
