Table of Contents
Advertisement
After connecting all the components, speakers, and AC power cord (mains lead), output a test tone to
check that all the speakers are connected correctly. For details on outputting a test tone, see page 85.
If no sound is heard from a speaker while outputting a test tone, or a test tone is output from a speaker
other than the one currently displayed on the Setup Display, the speaker may be short-circuited. If this
happens, check the speaker connection again.
Note
• Be sure to match the speaker cord to the appropriate terminal on the components: 3 to 3, and # to #. If the cords
are reversed, the sound will lack bass and may be distorted.
Installing the speakers on the wall
1
Prepare screws (not supplied) that are suitable for the hole on the back of each speaker.
See the illustrations below.
25 mm (1 inch)
2
Fasten the screws to the wall.
For DAV-DZ100K
The screws should protrude 5 to 7 mm
(7/32 to 9/32 inch).
5 to 7 mm
7
(
/
to
32
3
Peel the seals off the two screw points on the rear of the speaker.
(DAV-DZ500KF only)
22
GB
5
4 mm (
/
32
9
/
inch)
32
inch)
4.6 mm
3
(
/
16
10 mm
13
(
/
For DAV-DZ500KF
The screws should protrude 7 to 8 mm
(9/32 to 11/32 inch).
7 to 8 mm
9
(
/
32
Hole on the back of
the speaker
inch)
inch)
32
11
to
/
inch)
32
165 mm
1
(6
/
inch)
2
Advertisement
Table of Contents
